DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 254 / 322

9

INSTALLATION OF CONTROL, SCANNERS AND FLAME DETECTORS
Wiring Base
Mount the wiring base on the burner or on a panel. The location should be free from excessive vibra-
tion and within the specified ambient temperature rating. The base may be mounted in any angular
position.
All wiring should comply with applicable electrical codes, regulations and local ordinances. Use
moisture resistant wire suitable for at least 90 degrees C. Good electrical wiring practice should be
followed to ensure an adequate ground system. Refer to Fireye Service Note SN-100 separately and
General Grounding Rules later in this document for grounding methods.
A good ground system should be provided to minimize the effects of AC quality problems. A prop-
erly designed ground system meeting all the safety requirements will ensure that any AC voltage
quality problems, such as spikes, surges and impulses have a low impedance path to ground. A low
impedance path to ground is required to ensure that large currents involved with any surge voltages
will follow the desired path in preference to alternative paths, where extensive damage may occur to
equipment.
Circuit recommendations are found on pages 38 through 43. Consult the factory for assistance with
non-standard applications.
WARNING: Installer must be trained and qualified. Follow the burner manufacturer’s
instructions, if supplied. Otherwise, proceed as follows:
WARNING: Controls require safety limits utilizing isolated mechanical contacts.
Electronic limit switches may cause erratic operation and should be avoided.
Care must be taken to NOT route the high energy ignition wire in close proxim-
ity to the flame sensor wiring, particularly when using MERT amplifier.