DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 46 / 322

GENERAL OPERATION
1 9
Temperature Configuration
MAIN MENU
→
TEMP CONFIG
1) High Limit Set Point: The temperature value at which the dryer will shut down due to
being over temperature. This value should normally be set no more than 30 degrees
above your current drying temperature.
2) Output – Low Fire: This is the minimum output signal value to the temperature
modulating motor. This value represents the minimum flame bypass setting for fuel
flowing to the dryer or the minimum amount the temperature modulating motor will
open relative to the output signal scale.
3) Output – High Fire: This is the maximum output signal value to the temperature
modulating motor. This value represents the maximum amount the temperature
modulating motor will open relative to the signal scale.
High Limit Status
The Temperature Configuration Screen shows the current status of the High Limit
safety. If the High Limit safety has been triggered, reset and investigate the cause of
the over temperature before continuing use of the dryer.
Autotune
Changes in fuel supply such as pressure or ambient temperature can cause the dryer to hunt
for the plenum temperature set point. If the fluctuations are more than +/- 10 degrees the
dryer should be auto tuned so that the temperature control system can gather the correct
44