DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 26 / 322

STARTUP PROCEDURE
7
10.4. Press YES to start the manual drying cycle or NO to edit the variables or
abandon the calculation.
10.5. The operator may also use this calculation when the dryer isn’t responding to
efforts to effectively control the desired moisture output in AUTO mode.
10.6. Allow the dryer time to completely process the grain that was at top of the
dryer when the cycle was started. This can be calculated by using the BPH RATE that
the dryer used to start the cycle and the total holding capacity of the dryer. For
example, if the dryer started a cycle at the rate above of 563.3 BPH and the holding
capacity for the dryer is 1000 bushels, the minimum time before the operator would
want to make any adjustment would be 1.8 Hours or about 108 minutes (1000 Bu. /
563.3 BPH = 1.77)
(For listed holding capacities, refer to literature or specification
charts)
10.7. Once the dryer has been allowed to run a complete cycle of grain through, and
the difference between the AVERAGE MINUTE MOISTURE and SET POINT MOISTURE
is 0.5% or less, the dryer can be switched to AUTO mode from the HOME SCREEN.
10.8. If the moisture difference is larger than 0.5% adjust the discharge rate in
MANUAL mode from the HOME SCREEN using the UP/DOWN arrow keys. Do not make
more than a 10% speed rate adjustment at one time. Repeat until the moisture
difference is 0.5% or less and the dryer is able to be placed in AUTO mode.
10.9. Another way of determining that the discharge moisture has “bottomed out”
is by looking at the 4 HR TREND. When the red line (discharge moisture content) has
flattened out, the rate can be changed. Adjust the discharge rate manually to get
closer to the target moisture or the dryer can be placed in AUTO mode.
24