DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 45 / 322

GENERAL OPERATION
1 8
Dryer Configuration
MAIN MENU
→
DRYER CONFIG
1) Dryer Capacity (5PT): The rated capacity of the grain dryer in wet bushels per hour. This
variable is configured from the factory and shouldn’t be changed unless instructed to do
so.
2) Feedroll Bu/Rev: The amount of dry bushels metered through the dryer during one
revolution of the metering roll. This is a nominal value set from the factory.
3) Max. Unload (Dryer): The maximum unload in dry bushels per hour that the dryer will
discharge. This variable is set from factory and shouldn’t be changed.
4) Max. Unload (System): The maximum unload in dry bushels per hour that the handling
system can move. This variable can be adjusted to compensate for the maximum flow
capacities of any handling equipment the dryer is discharging in to. For example: The dryer
is unloading into an air system and the maximum dry bushels the air system is rated for is
1500 BPH. The dryer however can discharge at a rate of 2000 BPH. The operator would
want to set this variable to 1400 BPH, to stay well below the capacity of the air system.
Therefore avoiding any potential problems with overloading the air system.
** The Maximum Unload of the System must always be equal to or less than the
Maximum Unload of the Dryer. **
5) Dryer Hold Capacity: The number of bushels that the dryer can hold.
6) Feedroll Timer: The amount of time needed for the dryer to shut down in the event that
the feedrolls stop turning.
7) Min. Feedroll Output: The minimum amount of discharge power output to engage the
feedroll monitor safety.
43