DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 20 / 322

STARTUP PROCEDURE
1
Startup Procedure
Safety Considerations
A clean dryer is an efficient dryer. Thorough inspection of the plenum heat
chamber and vacuum cooling chamber and cleaning if necessary is
recommended at least every 24 hours of operation.
Install burner covers
provided with dryer before cleaning to reduce amount of dust and foreign
material falling into fan hubs and burners. Clean screens on inside of plenum
heat chamber, then remove dust and foreign material from plenum floor. Inspect cooling
chamber and clean if necessary. Check the outside screens and clean if necessary. The area
around dryer should also be kept clean.
Accumulation of material on the heat deck, inner
screens or cooling floor can lead to dryer fires! Do not assume that the dryer is staying clean
on the inside. Check the dryer regularly and clean as needed.
Do not leave the burner covers in the plenum while drying. They can interfere with the flow
of air and foreign material through the Stay-Kleen system (see below).
Stay-Kleen Operation & Maintenance
The Stay-Kleen design provides a path for the fines, dust and foreign material that enters into
the heat and cool chambers of the dryer to escape back into the grain flow and discharge.
Certain drying conditions and poor grain quality will affect the efficiency of the Stay-Kleen
system.
There are adjustable filler plates added to each side of the cooling floor cover. These allow
you to narrow the gap between the center walk plate and the screen to keep larger, lighter
weight foreign material from being drawn back up into the cooling section. The default setting
for these plates is ¼” gap. Different grain conditions may influence the need to adjust this gap.
Delux does not recommend more than a ¼” gap.
The Stay-Kleen system operates best with the fresh air intakes open as far as possible (See
item 2 below). If it is necessary to close the intakes some to better cool the grain, be extra
attentive to the cleanliness of the inner chambers.
1) Check dryer thoroughly before starting
1.1.
Check and clean screens and plenum and cooling chambers.
1.2. Check metering system for foreign material and clean.
1.3. Check augers and auxiliary equipment for correct rotation.
18