DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 27 / 322

STARTUP PROCEDURE
8
11) Setting discharge rate (MANUAL MODE)
11.1.
Follow the steps outlined in step 10 (above) except leave the dryer in MANUAL
mode when the desired output moisture has been achieved. Adjust with the
UP/DOWN arrow keys on the HOME SCREEN as need for incoming moisture
fluctuations.
12) Setting discharge rate (AFTER SHUTDOWN)
12.1.
If the dryer had been running in AUTO mode prior to a shutdown, the mid grain
set point is still established and the dryer can startup in AUTO mode. Once the burner
switch is on and the plenum has reached the desired operating temperature, the
LOAD OPERATION switch can be turned METER. The feedrolls will slowly start to turn
as the grain in the grain in the dryer starts to warm up. There will a slight over/under
drying period while dryer begins to stabilize. Do not switch the controller to MANUAL
mode at any point before or during the warm up period. This would void the original
mid-grain set point from the previous AUTO drying period.
12.2. If the dryer had been running in MANUAL mode prior to shutdown, wait for the
plenum temperature to reach the desired operating temperature. Then, turn the
LOAD OPERATION switch to METER and continue running in MANUAL mode or use
the CALCULATE button to start a MANUAL DRYING CYCLE.
25