DeLUX MOISTURE Link G2 DP, Руководство по эксплуатации

Страница: 21 / 322

STARTUP PROCEDURE
2
2) Fresh-air intake ports
2.1. Fresh-air intake ports are provided to allow fresh air to flow directly to the fan(s). The
fan(s) cannot receive enough air directly through the grain being cooled so fresh-air
intake ports are provided. These ports allow the operator to have more control over
the outgoing temperature of the product being dried.
2.2. Settings: Open the doors tha t are labeled ‘Full Open’, located directly on the fan(s),
full open. Open other doors labeled ‘As Needed’ as far as possible while still cooling
the grain as needed. When the grain is not cool enough close the doors down that are
not located directly on the fan(s) - when grain is too cool open these doors. Keep all
doors that are being adjusted the same as each other. When drying low moisture
products, it may be necessary to adjust the plenum temperature down to get the
product as cool as desired.
2.3. CAUTION: Having the fresh air intake doors closed too far can decrease capacity and
cause excessive heat which could result in uneven moisture content of discharge
grain and in extreme conditions, fires on the heat deck or cooling floor.
3) Turn all switches to the OFF position
4) Turn dryer main disconnect ON
4.1. Main power light will illuminate.
5) Turn on POWER SWITCH to the RUN position
5.1.
Move the POWER SWITCH to the RUN position. Wait for the SAFETY STATUS screen
to appear on the HMI screen.
19