ImageCard/UltraGrafix (Express and Select Classes) User’s Guide
2-13
•
Select the "My computer" choice, and not the "Network" choice. If
the "My computer" choice is not available, make sure you have
logged on as the administrator.
•
Select the port to which you have connected the printer.
•
Do not select the "Enable printer pooling" choice when installing
the printer driver.
•
When the Manufacturers list appears, insert driver diskette 1 and
select the Have Disk button. If needed, select the Browse button to
specify the location of the printer driver diskette.
•
When the Printer Name box appears, change the printer name to
match the name on the front of your printer. For example, you
might change "DataCard Select Class" to "ImageCard S2" or
"UltraGrafix S". Do not use the <>:"/\ and | characters in the
name. The PC will not be able to enable the driver if you use those
characters.
•
Printer sharing is not supported by the current version of the
printer driver.
•
Do not print a test page as part of the installation. You must select
the ribbon type before printing a test page, as explained below.
•
Remove the current diskette and insert the next diskette when
prompted.
•
A Version Conflict dialog might appear during the installation. If
so, select Yes to keep the existing files on your PC.
6.
Remove the diskette and restart Windows NT when prompted after
the printer driver is installed.
Note: If you earlier asked to print a test page, test page messages
might appear at the same time as the prompt to restart Windows NT.
Even if the test page does not print, select "Yes" when the message
appears. Restart Windows NT and continue to follow this procedure.
7.
When the PC restarts, log in as the administrator again, and follow
instructions to update the printer firmware if prompted.
8.
If a message appears about updating the printer firmware, follow the
on-screen instructions to do this.
9.
If the PC attached to the printer has other users, set user permissions
to support printing or to prevent access to the printer. To change
access for other users, make sure you have restarted Windows NT
and then do the following:
a) From the Windows taskbar, select Start, then Settings, and then
Printers. The Printers window appears.