The function set-up provides quick access to all parameters
required for most water and wastewater applications
including:
•
Variable torque.
•
Constant torque.
•
Pumps.
•
Dosing pumps.
•
Well pumps.
•
Booster pumps.
•
Mixer pumps.
•
Aeration blowers.
•
Other pump.
•
Fan applications.
Among other features, it also includes parameters for
selecting the following:
•
Which variables to show on the LCP.
•
Digital preset speeds.
•
Scaling of analog references.
•
Closed-loop single-zone and multi-zone
applications.
•
Specific functions related to water.
•
Wastewater applications.
The quick menu
Q7: Water and Pumps
provides direct
access to some of the most important dedicated water and
pump features:
•
Q7-1: Special ramps (initial ramp, final ramp,
check valve ramp).
•
Q7-2: Sleep mode.
•
Q7-3: Deragging.
•
Q7-4: Dry Run.
•
Q7-5: End of Curve Detection.
•
Q7-6: Flow Compensation.
•
Q7-7: Pipe Fill (Horizontal Pipes, Vertical Pipes,
Mixed Systems).
•
Q7-8: Control Performance.
•
Q7-9: Min. Speed Monitor.
The
Quick Menu
parameters can be accessed immediately,
unless a password was created via 1 of the following
parameters:
•
Parameter 0-60 Main Menu Password
•
Parameter 0-61 Access to Main Menu w/o Password
.
•
Parameter 0-65 Personal Menu Password
.
•
Parameter 0-66 Access to Personal Menu w/o
Password
It is possible to switch directly between
Quick Menu
mode
and
Main Menu
mode.
[Main Menu]
This section is used for programming all parameters.
The
Main Menu
parameters can be accessed immediately
unless a password has been created via 1 of the following
parameters:
•
Parameter 0-60 Main Menu Password
•
Parameter 0-61 Access to Main Menu w/o Password
•
Parameter 0-65 Personal Menu Password
.
•
Parameter 0-66 Access to Personal Menu w/o
Password
For most water and wastewater applications, it is not
necessary to access the
Main Menu
parameters. The
Quick
Menu
, quick set-up, and function set-ups provide the
simplest and quickest access to the typical required
parameters.
It is possible to switch directly between
Main Menu
mode
and
Quick Menu
mode.
To create a parameter shortcut, press [Main Menu] for 3 s.
The parameter shortcut allows direct access to any
parameter.
[Alarm Log]
Shows an alarm list of the 5 latest alarms (numbered A1–
A5). To obtain more details about an alarm, press the
navigation keys to navigate to the alarm number and press
[OK]. Just before entering the alarm mode, information
about the condition of the frequency converter is
provided.
Auto
on
Reset
Hand
on
Off
Status
Quick
Menu
Main
Menu
Alarm
Log
Back
Canc
el
In
fo
OK
On
Alarm
Warn.
130BA027.10
Illustration 2.5 LCP
[Back]
Reverts to the previous step or layer in the navigation
structure.
How to Program
Programming Guide
MG20OB02
Danfoss A/S © 05/2018 All rights reserved.
15
2
2
Содержание VLT AQUA Drive FC 202
Страница 2: ......