Daedong DSC48, Руководство по ремонту

Страница: 258 / 290

7
-18 Apr. 2007
DSC48
3.3 CHECK FOR NORMAL OPERATION
3.3.1 IGNITION SWITCH
Initial operation for the "ON" position
• Ignition switch: After turning it from the "OFF" to "ON"
position, all load lamps come on for 1.5
seconds.
• Ignition switch: Only No. 1 load lamp stays on for
1.5 seconds after turning the ignition
switch to the "ON" position.
3.3.2 CHECKING EACH LEVEL
A. LOAD LEVEL DISPLAY
1. Keep depressing the clutch pedal.
2. Set the straw sensor ON.
3. Start the engine and engage the threshing clutch
(threshing unit switch: ON).
4. Maintain the speci fi ed engine speed.
5. Move the shift lever to the "Forward" position.
6. Increase and decrease the engine rpm with the ac-
celerator lever to check if the load level is displayed
correctly according to the difference between the max.
engine speed without load when starting reaping and
current engine speed during reaping.
3.4 TROUBLESHOOTING
Symptom Cause Action
All load lamps do not come
on. • Power is not supplied to the MICOM unit.
• Faulty ground of the MICOM unit • Power to MICOM unit
• Ground of MICOM unit
The load lamps do not come
on in the correct order. • Faulty straw sensor, threshing unit switch, vehicle
speed sensor, or electronic pick up sensor
• Check sensors