CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 47 / 118

5
CUES Inc. , LAMPII User Manual | LM903
43
www.cuesinc.com , | salesinfo@cuesinc.com
===CUES K2 EQUIPMENT CONFIGURATION ===
REV: R011 CONFIGURATION CORRECT? NO
REEL: K2 Portable CONFIG. REELS? NO
CABLE: WM305(Platinum)
LENGTH: 10 FT.
CAMERA: 0.01080 OHMS/FT.
LIGHTS: 0.02320 OHMS/FT.
LEFT MOTOR: 0.01080 OHMS/FT.
RIGHT MOTOR: 0.01080 OHMS/FT.
TRANSPORTER: LAMPII
FRONT VIEWING CAMERA: NONE
REAR/LATERAL VIEWING CAMERA: NO
CAMERA LIFT: None
LIGHTS: None
AUDIO: MIKE SPK VOL: 0 SPK ON/OFF: OFF
ARROW UP/DOWN to view correctness list
To ensure proper equipment operation and to prevent equipment damage (over-voltage), ensure
that the TRANSPORTER field is set to LAMPII on the Equipment Configuration Screen (shown
below). Please refer to the K2 User Manual regarding how fields work, the types of fields, etc.
LABEL: TRANSPORTER
Type - stored field, dependent on TYPE
Selections – None, Shorty, Ultra-Shorty, Steerable Pipe Ranger, Pipe Ranger, Steerable Mud
Master, Mud Master, Koala, Compact Pipe Ranger, Ultra-Shorty-21, Ultra-Shorty-III, WTR,
LAMPII
Default - None
Status Line - ARROW UP/DOWN to view transporter list.
Ensure the unit is set to run
the LAMPII
MULTI CONDUCTOR EQUIPMENT CONFIGURATION SCREEN
Refer to the acceptance test procedures in P/N LM350 & MZ300 and ensure the equipment
is functioning properly (using the Game Pad or Hand Held Controller as shown on the subse-
quent pages):
• Camera moves, functions work
• Push cable extend and retract
• Lights work; push camera lights DIM / BRIGHTEN
• Transporter moves FORWARD / BACKWARDS
• Ensure that the video is displayed on the monitor; clean the lens if necessary
• Check / verify the footage accuracy