CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 34 / 118

4
30
CUES Inc. , LAMPII User Manual | LM903
www.cuesinc.com , | salesinfo@cuesinc.com
SYSTEM SET-UP & INSTALLATION
LINE TRACING CABLE EXTENSION WITH LAMPII - (FIBERGLASS PUSH CABLE
CONFIGURATION):
A terminal post is available on the LAMPII Reel for connection of a transmitter (MS250, Prototek
BuzzBox), for line tracing purposes (quick, accurate line and utility locating). Extended cables
(LM600-15, LM600-30, & LM600-50) are available for use when using the line tracing feature
with the LAMPII. Reference the photos on the opposite page with the terminal in red.
Cable P/N’s LM600-15, -30, or -50 (depending on desired footage length) should only be used to
connect the reel and the BuzzBox, P/N MS250, during line tracing. When not in use, the transmitter
should be turned OFF (per the manual), and the LM600 cable should be detached from the reel.
If not detached, the cable will act as a massive antenna on the ground line and could induce video
noise. Refer to the Transmitter Manual for detailed operation instructions.
P/N LM600 (and applicable dash numbers) can be used to extend the cable length for the MS250
(Prototek BuzzBox) when using line tracing with the LAMPII.
To use the cable:
1. Connect the red clamp from cable P/N MS250 to the mounting post of the reel, Item #42,
of P/N LM360.
2. Then connect the black clamp from cable P/N MS250 to the banana plug of P/N LM600.
3. The black clamp of P/N LM600 should be connected to earth ground as explained
in the Prototek user’s manual. This manual comes with P/N’s MS250 and MS327 (Prototek
LF2200).
IMPORTANT: The LM600 should ONLY be used during line tracing. It will act as a massive antenna
on the ground line and could induce video noise. It should be detached when not in use.
Refer to the Transmitter Manual for detailed operation instructions.