CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 17 / 118

4
CUES Inc. , LAMPII User Manual | LM903
13
www.cuesinc.com , | salesinfo@cuesinc.com
3. Guide the cable into the channel and install the guide
plate to capture the push cable.
4. To install the pressure plate, apply blue threadlocker to
all screw threads and secure the screws. Adjust the set
screw on the pressure plate to provide the lightest
possible pressure against the cable.
5. Turn ON the reel controller and set to REAR and
RELEASE. Ensure that the cable easily unrolls from
the reel.
SPEED AND FORCE ADJUSTMENT -
Spring Push Cable System:
To ensure the lateral cable unrolls easily, perform the
following:
• When driving the launcher forward or extending
the lateral camera, the lateral reel RETRIEVE/
RELEASE switch must be set to RELEASE - or -
• the lateral reel controller power switch must be in
the OFF position
FOR STAINLESS STEEL PUSH CABLE ASSEMBLIES ONLY:
When retracting the lateral camera:
• Ensure that the lateral reel RETRIEVE/RELEASE switch is set to RETRIEVE.
• Adjust the SPEED/FORCE knobs clockwise to the desired position.
• Recommended initial settings: SPEED: 12 o’clock FORCE: 1 o’clock
When pulling the launcher backwards:
• Ensure that the lateral reel RETRIEVE/RELEASE switch is set to RETRIEVE.
• Adjust the SPEED/FORCE knobs clockwise to the desired position to keep up with the gold cable
speed.
• Recommended initial settings: SPEED: 12 o’clock FORCE: 1 o’clock
• Retrieval speed will vary depending on the pipe condition and wheel configuration.
• To prevent the transporter from driving over the cables and hindering retrieval, use caution and
do not allow the transporter to track faster than the lateral reel.
• Recommended settings: Gold Cable retrieval speed should be set according to pipe conditions
with cables visually monitored for synchronization to prevent potential damage to the equipment.
3
4
5