CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 28 / 118

4
24
CUES Inc. , LAMPII User Manual | LM903
www.cuesinc.com , | salesinfo@cuesinc.com
SYSTEM SET-UP & INSTALLATION
LAMP II PUSH WHEEL REPLACEMENT GUIDE
Due to normal wear and tear, the plastic push cable may begin to slip during operation. To
compensate for this, CUES offers three different push wheels in various sizes. As the cable begins
to wear, follow the steps below and the diagram on the opposite page to change the push wheels
to the next set of larger wheels. Start with the standard wheels, then move to the oversized
wheels, and finally move to the double-oversized wheels.
Note: Top and bottom orientations are for the push block, which sits upside-down in the LAMP II.
1. Replace the bottom wheels on the corners as indicated. Refer to the image on the opposite
page. Push wheels are labeled per each applicable step that requires a change. Each step
involves changing two push wheels. Reinstall the push cable and operate the LAMP II in
this configuration until cable slippage starts and then proceed to next step.
2. Replace the bottom wheels on the other two corners. All bottom rollers are now the larger
size and all top rollers are the smaller size. Reinstall the push cable and operate the
LAMP II in this configuration until cable slippage starts and then proceed to next step.
3. Replace the top wheels on the two corners as indicated. Reinstall the push cable and
operate the LAMP II in this configuration until cable slippage starts and then proceed to
next step.
4. Replace the top wheels on the other two corners. Now all push wheels have been changed.
Reinstall the push cable and operate the LAMP II in this configuration until cable slippage
starts and then proceed to the next size push wheels.