CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 14 / 118

4
10
CUES Inc. , LAMPII User Manual | LM903
www.cuesinc.com , | salesinfo@cuesinc.com
SYSTEM SET-UP & INSTALLATION
ADAPTING THE LAMPII TO DIFFERENT PIPE CONFIGURATIONS
The adaptation of the LAMPII to different pipe sizes is accomplished by changing the wheels. The
wheel sets adjust to allow for the inspection of 6” through 36” diameter pipelines. This is accomplished
by adding various types and quantities of wheels and spacers
. The wheels and spacers not only widen
the base of the transportation platform for stability, but also positions the LAMPII approximately in the
center of the pipe for optimum viewing.
The LAMPII incorporates the new quick-change wheel assemblies that are designed for maximum
efficiency and ease-of-use.
To remove the wheels:
IMPORTANT! When changing wheels, always apply anti-sieze compound, P/N CS407 or P/N 940700
grease, to all screw threads.
1. For 6” rubber and steel wheel assemblies, loosen the large center captive screw using a socket.
For 8” - 15” wheel assemblies, loosen and remove the large center screw using an Allen wrench.
2. Separate the wheel assembly and spacer, if applicable, from the shaft.
3. For 24” - 36” wheel assemblies, refer to the instructions in P/N LM931-INST for more information.
To mount the wheels:
4. Select the appropriate wheel, spacer, and screw, if applicable, for the pipe size to be
inspected. If necessary, refer to the wheel matrix shown in the previous chapter.
5. Install the spacer, ensuring that the tri-lobe pocket on the spacer is aligned with the tri-lobe
on the shaft.
6. Hold the wheel and spacer against the LAMPII shaft and secure the appropriate screw
using an Allen wrench.
7. Tighten to 15 ft. lbs.
IMPORTANT!
When changing wheels, always apply
anti-sieze compound, P/N CS407 or P/N
940700 grease, to all screw threads!