CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 59 / 118

6
CUES Inc. , LAMPII User Manual | LM903
55
www.cuesinc.com , | salesinfo@cuesinc.com
CENTERING THE LAMPII IN THE PIPE
To ensure the LAMPII is level and centered in the pipeline, it will be necessary to periodically check
the orientation with reference to the waterline in the pipe. To check the orientation:
1. Stop the LAMPII.
2. Press the HOME Pan & Tilt button on the LAMPII controller and wait for the camera head to
‘home’.
3. To level and center the LAMPII orientation, put the mainline cable reel in gear to hold the
transporter in place and run the transporter at full speed until the LAMPII is level and centered
in the pipe.
4. Verify the level and orientation and then continue with the inspection. NOTE: To ensure the
unit remains stable in operation, perform this procedure before entering each lateral.
CHANGING DIRECTIONS
1. To change from forward to reverse free wheel, allow the LAMPII to come to a complete stop
before moving in the opposite direction.
2. After the LAMPII has stopped, move the directional switch on the transporter controller or K2
game pad controller (depending on your specific system) to REVERSE.
3. Advance the speed control to a low motor speed. The clutch will disengage after approximately
two seconds and the LAMPII will begin to move rearwards. The transporter is now ready to
freewheel in reverse.
4. Use the reel to pull the LAMPII back towards the control point and entry manhole.
5. To use the power reverse, make sure the directional switch on the transporter controller or K2
game pad controller (depending on your specific system) is set to REVERSE and then slowly
advance the speed control.