CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 118

4
CUES Inc. , LAMPII User Manual | LM903
23
www.cuesinc.com , | salesinfo@cuesinc.com
SPEED AND FORCE ADJUSTMENT: Fiberglass Push Cable System
To ensure the lateral cable unrolls easily, perform the following:
• When driving the launcher forward or extending the lateral camera, the lateral reel RETRIEVE/
RELEASE switch must be set to RELEASE - or -
• the lateral reel controller power switch must be in the OFF position
When retracting the lateral camera:
• Ensure that the lateral reel RETRIEVE/RELEASE switch is set to RETRIEVE.
• Adjust the SPEED/FORCE knobs clockwise to the desired position.
• Recommended initial settings: SPEED: 3 o’clock FORCE: 9 o’clock
When pulling the launcher backwards:
• Ensure that the lateral reel RETRIEVE/RELEASE switch is set to RETRIEVE.
• Adjust the SPEED/FORCE knobs clockwise to the desired position to keep up with the gold cable
speed.
• Recommended initial settings: SPEED: 3 o’clock FORCE: 9 o’clock
• Retrieval speed will vary depending on the pipe condition and wheel configuration.
• To prevent the transporter from driving over the cables and hindering retrieval, use caution and
do not allow the transporter to track faster than the lateral reel.
• Recommended settings: Gold Cable retrieval speed should be set according to pipe conditions
with cables visually monitored for synchronization to prevent potential damage to the equipment.
IMPORTANT NOTES FOR THE LM920 WHEEL KIT (for use with fiberglass push cable
assemblies only):
• The LM920 wheel kit is available to optimize push drive performance and extend cable life
for fiberglass core lateral push cable systems.
• The larger push drive wheels are identified by ‘O/S’ (oversize) markings on the top or bottom
face for the top and bottom rollers, respectively.
• The LM920 wheel kit should never be used with new cable or cable that has not been
reversed to ensure wear consistency. Improper use of the wheel kit may result in reduced
push drive performance or failure.
• Prior to installation of the LM920 wheel kit, the lateral push cable should be reversed, swap-
ping the camera and reel ends, to ensure that wear is consistent throughout the length of
the cable.
• LM920 BOM and exploded view drawings are included in Chapter 7.
WHEEL KIT CONFIGURATION TABLE
KIT P/N DESCRIPTION
LM919 KIT,STD PUSH WHEELS,ALT,LAMPII
LM920 KIT,LARGE PUSH WHEELS,ALT,LAMPII