CUES LAMP II, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 118

4
28
CUES Inc. , LAMPII User Manual | LM903
www.cuesinc.com , | salesinfo@cuesinc.com
SYSTEM SET-UP & INSTALLATION
HOW TO FLIP THE FIBERGLASS PUSH CABLE
Perform this procedure to prolong the cable life. Refer to the previous sections for more detailed
intructions of specific procedures.
To flip the cable:
1. Remove the cable from the LAMPII transporter.
2. Unscrew the spring end from the push cable.
3. Pull out the entire length of the push cable from the reel.
4. Detach the push cable from the lateral video cable.
5. Attach the other end of the push cable to the lateral video cable.
6. Use the reel controller to wind up the push cable only, leaving enough to install into the
LAMPII launcher.
7. Reinstall the spring end.
8. Reinstall the push cable into the LAMPII launcher.
HOW TO REPLACE WORN BUMP STOPS
If removable bump stops are present, follow the procedure below for replacement:
1. There are (2) screws, (1) located on each bump stop. Using an Allen Wrench, remove the
(2) screws as shown.
2. Replace with new bump stops, P/N LM718.
3. Apply blue loctite and secure using an Allen Wrench.
NOTE: In the first quarter of 2016, all LAMPII’s will be manufactured with replaceable bump
stops to ensure proper camera alignment within the pipeline. Refer to the INSTALLING THE
LAMPII IMMOBILIZING BLOCK procedure in this chapter for pictures to differenciate between
the old versus new bump stops.
Bump Stops, P/N LM718