CR Remeha Avanta 12v, Инструкция по установке и обслуживанию

Страница: 66 / 110

[P][2][3]
Connection with Heat
Recovery Unit (HRU) 0 = no connection with HRU
1 = connection with HRU 0
[P][2][4]
State remote alarm
(X7 terminal) 0 = off
(connectors 1 and 2 closed)
1 = alarm signal
(connectors 1 and 2 closed)
2 = run indication
(connectors 1 and 3 closed)
3 = ext. gas valve
(connectors 1 and 3 closed)
4 = external pump relay
(connectors 1 and 3 closed) 0
[P][2][5]
Legionella protection 0 = off
1 = on
2 = automatic (after putting
boiler into operation, it will
run
for DHW operation 65°C once
a week) 0
[P][2][6]
DHW cut-in
temperature 2 - 15°C 5
5)
[P][2][7]
Heat curve set point
flow temperature 0 - 60°C 20
[P][2][8]
Heat curve set point
outside temperature
(min) 0 - 30°C 20
[P][2][9]
Heat curve set point
outside temperature
(max) -40 - 0°C - 15
4)
[P][3][0] Boiler type Do not change 3
[P][3][1]
Set point augmentation
calorifier 0 - 20°C 15 5)
[P][d][F]
([P][d][U]
is shown
later
Restore factory
settings On identification
plate
[d][F] setting X is
shown.
Change parameter into X will
restore the factory settings,
see
par. 2.10.10 .
X
On identification
plate
[d][U] setting Y is
shown.
Change parameter into Y will
restore the factory settings,
see
par. 2.10.10 .
Y
table 09 Settings at service level
1)
Do not exceed this value.
2)
The boiler in combination with an external calorifier will not warm up the calorifier in the Eco-mode.
3)
Only change for propane firing.
4)
"Minus" character is not shown in display.
5)
Only in combination with a calorifier with a DHW sensor.