Use and Maintenance Manual – 08/2018 Rel. 3
Page 41
030
Wait to hear the long acquisition beep and then set the
sensor back to the rest position. During acquisition the
distance and diameter values are displayed on the wheel
dimension data band.
040
Lower the wheel guard to run the balancing
launch and to activate the SONAR device (in
this way you automatic enter the width of the
wheel).
ALU1, 2, 3, 4, 5 Program Type selection
Phase
Description
010
Fit the wheel on the shaft and tighten with the ring nut.
020
Extract the distance/diameter sensor and place it on the rim
as shown here.
When the distance/diameter sensor come back in rest
position it is automatically activated the STANDARD
program
.
030
Wait to hear the long acquisition beep and then set the
sensor back to the rest position. During acquisition the
distance and diameter values are displayed on the wheel
dimension data band.
