Use and Maintenance Manual – 08/2018 Rel. 3
Page 50
040
If the wheel’s static imbalance is less than 12 grams, the
ERR 055
error message will appear and it will automatically exit the
OPTIMIZATION program. If, on the other hand the wheel’s static
imbalance is greater than 12 grams, the machine will start the
OPTMIZATION program.
050
Position the valve at 12 o’clock, make a mark on the tyre where
the valve is and press [P6]
on the keyboard.
060
Remove the wheel from the shaft, remove the tyre bead, rotate
it so that the mark is at 180° with respect to the valve.
Re-install the wheel on the shaft, and erase the mark made
previously.
Lower the wheel guard: the machine will run a launch.
070
At the end of the launch, place the valve at 12 o’clock and press
[P6]
on the keyboard to continue. In this case the
message seen in figure for the next phase will appear.
080
Rotate the wheel until all position arrow LEDs light up and then
mark the 12 o’clock position and press key [P6]
on the
keyboard.
