Use and Maintenance Manual – 08/2018 Rel. 3
Page 51
090
Remove the wheel from the balancing machine, remove the bead
from the tyre and rotate it until the valve matches the mark on
the tyre. Optimization is finished: exit the optimization menu by
pressing [P5]
.
100
Remount the wheel on the balancing machine and balance it with
the normal procedure.
NOTE: it is possible to exit the optimization procedure at any time by repeatedly pressing [P5]
.
19. HIDDEN WEIGHTS PROGRAM
This program divides the external weight “W” in two weights “W1” and “W2” (smaller than the initial external weight W) located in
any two positions selected by the operator. The two weights “W1” and “W2” must form a maximum angle of 120° including the
external weight W. The Hidden Weights Program is used for aluminum rims when:
•
You want to hide the external weight behind two spokes for aesthetic reasons;
•
The position of the external weights coincides with a spoke therefore a single weight cannot be applied.
NOTE: This program can be used with any Program Type and with any Wheel Type. It can also be used to divide the static weight into
two separate weights (especially useful with wheels for motorbikes).
NOTE: the screen relative to phase 050 indicates the position of the external weight at the 12 o’clock position but this is valid only for
certain Program Types. Table T17.2 shows the actual position of the external imbalance based on the Program Type and on the
enabling state of Distance/Diameter sensor.
19.1 Hidden Weights Program with distance/diameter sensor gauge (without LASER)
To access the HIDDEN WEIGHTS program, proceed as described below:
Phase
Description
010
Apply the internal weight, stated on the left display, on the rim.
