Use and Maintenance Manual – 08/2018 Rel. 3
Page 14
10.3 Presentation of the machine
1.
Keyboard.
2.
Weight-tray.
3.
Monitor.
4.
Wheel guard with support.
5.
Width Sensor (only MEC 820VD).
6.
Rocking unit.
7.
Distance/Diameter sensor.
8.
Pins for cones.
Figure F10.1
11. SERIAL NUMBER PLATE INFORMATION
12. ORDINARY MAINTENANCE
To ensure the efficiency of machine and its proper functioning is essential to follow the manufacturer’s instructions by performing
periodic cleaning and routine maintenance.
CLEANING AND ORDINARY MAINTENANCE MUST BE PERFORMED BY THE AUTHORIZED PERSONNEL IN
ACCORDANCE WITH THE MANUFACTURER INSTRUCTIONS PROVIDED BELOW.
Always keep the flanges clean (non-lubricated). In addition, during the handling, pay the best attention to not damage them. For
cleaning the machine, especially for the weight-tray, use a soft cloth moistened with ethyl alcohol.
EVERY OPERATION MUST BE DONE ONLY AFTER THE CABLE HAS BEEN DISCONNECTED FROM ITS POWER
SUPPLIER.
DO NOT BLOW COMPRESSED AIR TO CLEAN THE MACHINE AND LASER POINTER.
DO NOT USE WATER OR OTHER LIQUIDS FOR CLEANING THE MACHINE.
1
2
3
4
5
6
7
8
