Comtech EF Data CDM-625, Инструкция по установке и эксплуатации

Страница: 286 / 322

CDM-625 Advanced Satellite Modem Revision 1
Remote Control MN-0000036 (Ref MN/CDM625.IOM)
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction
& Qualifier)
Response to Query
EDMAC Slave
Address
Range ESA= 4 bytes
Command or Query.
EDMAC Slave Address Range - sets the range of addresses of
distant-end units (modems or transceivers) that this unit, as the
Master, will forward messages for. Only values which are integer
multiples of ten are permitted. (0010, 0020, 0030, 0040 etc.)
Example: ESA=0090
This command is only valid for an EDMAC master. When used as a
Query, it may be sent to an EDMAC slave, which will respond with
the appropriate address.
ESA=
ESA?
ESA*
ESA# ESA? ESA=xxxx
(see description of
arguments)
Engineering
Service
Channel ESC= 1 byte, 0 or 1
Command or Query. (IBS and ESC++ feature)
Format:
ESC=x
where: x = 0 (Disable the high-rate ESC)
x = 1 (Enable the high-rate ESC)
IBS ESC may only be enabled when:
1. Both Tx and Rx framing modes are set to IBS.
2. Data rate is not 1544 kbps (as spare overhead bits are not
available in this mode).
3. IBS high-rate ESC FAST option is enabled.
ESC=
ESC?
ESC*
ESC# ESC? ESC=x
(see description of
arguments)
D–26