Comtech EF Data CDM-625, Инструкция по установке и эксплуатации

Страница: 292 / 322

CDM-625 Advanced Satellite Modem Revision 1
Remote Control MN-0000036 (Ref MN/CDM625.IOM)
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction
& Qualifier)
Response to Query
Initialize
Statistics
Pointer ISP= None Command only.
Resets internal pointer to allow RNS? queries to start at the
beginning of the statistics log.
ISP=
ISP# N/A N/A
Force 1:1
Switch FSW= None
Command only.
Forces the unit to toggle the Unit Fail relay to the “fail” state for
approx 500ms. If the unit is a 1:1 pair, and it is currently the ‘On-
Line’ unit, this will force a switchover, so the unit will then be in
‘Standby’ mode. The command is always executed by the unit,
regardless of whether it is stand-alone, in a 1:1 pair, or part of a 1:N
system.
This command takes no arguments.
FSW=
FSW* N/A N/A
Outdoor Unit
Comms
enable ODU= 1 byte, 0 or 1
Command or Query.
Enables or disables communications, via the FSK link, with a
Comtech EF Data transceiver (ODU), where:
0=Disabled
1=Enabled
Example: ODU=0 (selects Disabled)
ODU=
ODU?
ODU*
ODU# ODU? ODU=x
(see description of
arguments)
1:N (One For
N) control OFN= 1 byte, 0 or 1
Command or Query.
Enables or disables the 1:N control. This affects a control line on the
25-pin rear panel connector. This must be enabled when the modem
is attached to a CRS-300 1:N controller. The argument may be:
0=Disabled
1=Enabled
Example: OFN=0 (selects Disabled)
OFN=
OFN?
OFN*
OFN# OFN? OFN=x
(see description of
arguments)
D–32