Comtech EF Data CDM-625, Инструкция по установке и эксплуатации

Страница: 79 / 322

CDM-625 Advanced Satellite Modem Revision 1
Front Panel Operation MN-0000036 (Ref MN/CDM625.IOM)
5.4 SELECT: Configuration
CONFIG: All Mode Tx Rx Clocks D&I
CnC EDMAC Misc Mask Remote IP (
34
)
Use the ◄ ► arrow keys to select from the submenu choices shown, then press
ENTER
. The
submenus available from the Configuration menu are as follows:
Submenu Description
All
Permits the user to completely configure the unit, being prompted, step by step,
to make choices, or edit data. This is highly recommended for new users, as it
will clearly lead the user through all the configuration parameters.
Mode
Permits the user to select Frame Type and Data Format for Tx and Rx.
Tx
(Transmit)
Permits the user to define, on a parameter-by-parameter basis, the
Tx configuration of the unit. These menu submenu branches would be used if the
user wished to change, for example, just the Tx Frequency.
Rx
(Receive)
Permits the user to define, on a parameter-by-parameter basis, the Rx
configuration of the unit. These menu submenu branches would be used if the
user wished to change, for example, just the Rx data rate.
Clocks
Permits the user to select Tx-Clocking, Rx-Buffer/Clock, or External Reference.
D&I
Permits the user to select (Quad) Drop & Insert options.
CnC
(DoubleTalk
®
Carrier-in-Carrier
®
)
Permits the user to select DoubleTalk
®
Carrier-in-Carrier
®
(CnC) options.
EDMAC
Permits the user to select EDMAC options.
Misc
(Miscellaneous)
Permits the user to select, view, or change various other
parameters.
Mask
Permits the user to activate or MASK an alarm condition.
Remote
(Remote Control)
Permits the user to define whether the unit is being controlled
locally, remotely, or via IP, and to configure the serial Remote Control
parameters: baud rate, I/O format, address.
IP
Permits the user to configure various IP parameters, including IP address,
gateway and MAC addresses.
IMPORTANT
Only one method of remote access may control the modem at a time. The
modem may be monitored over the remote control bus at any time (i.e.,
queries only), and the front panel may be viewed.
To make configuration parameter changes from the front panel, local
mode is required. Via serial remote, remote mode is required, and via IP,
Ethernet remote is required.
5–7