ComAp InteliDrive DCU Industrial, Глобальное руководство

Страница: 98 / 350

InteliDrive DCU Industrial 3.4.0 Global Guide
98
Controller objects
8.1 List of controller objects types
8.1.1 Setpoints 98
8.1.2 Binary Inputs 159
8.1.3 Binary outputs 187
8.1.5 Values 253
6
back to Appendix
8.1.1 Setpoints
What setpoints are:
Setpoints are analog, binary or special data objects which are used for adjusting the controller to the specific
environment. Setpoints are organized into groups according to their meaning. Setpoints can be adjusted from
the controller front panel, PC, MODBUS, etc.
Each setpoint can be protected by a password against unauthorized changes. Password protection can be
assigned to the setpoints during the configuration procedure.
IMPORTANT: Do not perform repeated writing of setpoints (e.g. do NOT have a MODBUS
’watchdog’ system where PLC periodically writes down a figure into register and then reads the
figure). The setpoints are stored in EEPROM memory, which can be overwritten up to 100 000 times
without risk of damage or data loss, however it may become damaged, when allowed number of
writing cycles is exceeded!
The issue with EEPROM memory limit is resolved from ID-DCU Industrial firmware version 2.2,
setpoint registers were moved into another memory part of the controller.
List of setpoint groups
Password 101
Access code 101
Engine commands and Statistics protection 102
Basic settings 103
Comms settings 109
Engine params 115
Engine protect 124
RPMdep protect (AS only) 133
Load sharing 138
Analog inputs 145
Date and Time 153
ID-SCM unit 155
Protections 159
For full list of setpoints go to the chapter List of setpoints (page 99)
6
back to Controller objects