Connect the CIO-MICRO I/O Module (Optional)
The vision system can access the CIO-MICRO I/O module's general-purpose input and output lines via an Ethernet
connection to the I/O module. Optionally, the I/O Module cable can be connected to access the I/O module's ,
TRIGGER-, HS OUT 0, HS OUT 1 and HS COMMON lines.
Note
:
l
When the vision system is connected to the I/O Module cable:
l
Illumination accessories attached to the vision system faceplate or LIGHT connector are not
supported. If these illumination accessories are attached, the Breakout cable must be used to supply
power to the vision system and a connection to the I/O module established via Ethernet only.
l
The vision system's IN 1, IN 2 / HS OUT 2, and IN 3 / HS OUT 3 lines are not supported.
l
HS OUT 0 and HS OUT 1 are configurable as NPN (current sinking) or PNP (current sourcing) with 50mA
maximum current and the general-purpose outputs are configurable as NPN (current sinking) or PNP
(current sourcing) with 100mA maximum current.
l
The CIO-MICRO I/O module does not support Gigabit pass-through operation. If you need Gigabit operation,
connect a LAN cable from a Gigabit Ethernet switch to the I/O module’s LAN port and connect the vision
system Ethernet cable to the Gigabit Ethernet switch.
l
Perform wiring or adjustments to I/O devices when the vision system is not receiving power.
I/O Port
Connects the I/O module to the vision system using the I/O Module cable, and provides
power, trigger and high-speed output signals to the vision system.
MODULE OK LED
Illuminates after the I/O module has powered on, has booted up, and is ready to
communicate with the vision system.
COMM OK LED
Blinks continuously until the vision system has established a successful connection to the
I/O module from In-Sight software. Once successfully connected and communicating
properly, the green LED is constantly illuminated.
PoE STATUS LED
Not supported. When the vision system is connected to the I/O module's PoE port, the POE
STATUS LED may blink. This is normal and does not affect operation of the vision system.
PoE Port
Connects the I/O module to the vision system, providing the vision system with Ethernet.
The green LED blinks when a network connection to the vision system is detected. The
orange LED blinks when network activity is detected.
50
Installation
Содержание In-Sight 7600
Страница 1: ...In Sight 7000 Gen2 Series Vision System Reference Guide 2020February06 Revision 5 8 1 2...
Страница 42: ...42 Installation...
Страница 43: ...43 Installation...
Страница 113: ......