3. Plug the PCB into the lighting connector on the vision system faceplate.
CAUTION
:
If uninstalling the PCB from the vision system, refer to
Remove the Illumination Accessory PCB
for steps to safely remove the PCB and avoid damage to the vision system.
4. Install the spacer.
a. Place the spacer on top of the vision system with “TOP” oriented upward.
b. Verify seating of the gasket on the bottom of the spacer.
c. Insert the four M3 screws and use a 2mm hex wrench to torque screws to 0.34 Nm (3 in-lb). For the 7500,
7501, 7600, 7800, 7801, 7802, 7900, 7901 and 7902, use the M3 x 6mm screws. For the 7802P, 7902P
and 7905, use the M3 x 8mm screws.
34
Installation
Содержание In-Sight 7600
Страница 1: ...In Sight 7000 Gen2 Series Vision System Reference Guide 2020February06 Revision 5 8 1 2...
Страница 42: ...42 Installation...
Страница 43: ...43 Installation...
Страница 113: ......