Cognex In-Sight 7600, Справочное руководство

Страница: 45 / 113

Install the Mounting Bracket (BKT-INS-01)
Complete the following steps to attach the accessory mounting bracket (BKT-INS-01) to the vision system.
Note :
l
When attaching the vision system to the mounting bracket:
l
If using the M3 screw holes, the thread length of the M3 screw should not exceed 7mm.
l
If using the 1/4 - 20 screw holes, the thread length of the screw should not exceed 10mm.
For more information, see Mounting Bracket (BKT-INS-01) on page 105 .
CAUTION : The vision system should be grounded, either by mounting the vision system to a fixture that is
electrically grounded or by attaching a wire from the vision system’s mounting fixture to frame ground or Earth
ground. If a ground wire is used, it should be attached to one of the four mounting points on the back plate of the
vision system and not to the mounting points on the front of the vision system.
1. Align the mounting bracket with the mounting holes on the vision system. If using the M3 mounting holes, the
mounting bracket can be attached in either orientation.
2. Insert the M3 screws into the mounting holes and tighten. The maximum torque is 0.90 Nm (8 in-lb).
45
Installation