CNSystems CNAP Monitor 500 HD, Руководство оператора

Страница: 73 / 121

NBP
CNAP
®
Monitor 500 Page 9-3 Version 5.2.5,
h
21-FHZU-10002
9.3 Setup
The CNAP
®
hardware consists of the following components:
CNAP
®
double finger cuff
CNAP
®
controller
CNAP
®
cable
Graphics to select correct finger
cuff size
Illustration 42: CNAP
®
hardware
NOTE:
•
CNSystems recommends placing the CNAP
®
double finger cuff on the index and the
middle finger of a patient. In rare cases – if necessary – the CNAP
®
double finger cuff
may also be placed on the middle and the ring finger. Thumb and little fingers are
not suited for CNAP
®
blood pressure measurement.
•
The use of a too big/too small CNAP
®
double finger cuff may result in faulty blood
pressure recordings.
Selection of the appropriate finger cuff
Choose the right size of the finger cuff by using the graphic on
the CNAP
®
controller.
Place the patient’s finger on the graphic flush with the grey line
on the left and estimate the cuff size on the proximal phalanx.
The smallest visible indicator shows the appropriate cuff size
(see illustration).
Checking the finger cuff size
At the start of a measurement the optimal fit of the finger cuff is
tested. If the cuff doesn’t fit an advisory message will imme-
diately be shown on the CNAP
®
Monitor giving that information
to the user.
1
3
2
4
Illustration 43: Selection of
appropriate
CNAP
®
finger
cuff
Distributed by BIOPAC Systems, Inc. Manufactured by CNSystems AG