CNSystems CNAP Monitor 500 HD, Руководство оператора

Страница: 36 / 121

Monitor configuration
CNAP
®
Monitor 500 Page 4-6 Version 5.2.5,
h
21-FHZU-10002
The additional features can be activated by entering a valid license key in the menu
Setup/Monitor/Device Features/License Key . To get the license keys for activating features
contact your local distribution partner or CNSystems directly.
NOTE:
•
After activation of CNAP
®
-PPV or Hemodynamic with a license key the features are
disabled per default. These parameters can be enabled per default (via menu entry
Setup/Measurement/Hemodynamic ) or only for the current measurement in
the menu Hemodynamic/Hemodynamic .
The above mentioned features can be enabled permanently or for blood pressure, PPV and HD
measurements also for a limited number of measurements.
Each license key for enabling a limited number of measurements has a sequence number. It is
important to enter the license keys in ascending sequence. The sequence number of the next valid
key is displayed next to the number of available measurements.
Illustration 22: Overview of device features and sequence numbers for limited number of mea-
surements
4.5 BP Wave Out (patient monitors)
4.5.1 BP Wave Out configuration
Similar to the BP waveform obtained from an invasive catheter (e.g. radial artery), the CNAP
®
blood pressure waveform can be interfaced to patient monitors by means of the "BP Wave Out"
output port located on the left side of the CNAP
®
Monitor 500 (see chapter 3.2.1, illustration 2). As
can be seen from the graphics below, the CNAP
®
Monitor 500 can also be connected with the pa-
tient monitor by a) CNAP
®
Transducer Cable and b) IBP Interface Cable (see also chapter 17.2 -
Connections).
CNAP
®
Monitor 500 Transducer Cable Interface Cable Patient Monitor
Distributed by BIOPAC Systems, Inc. Manufactured by CNSystems AG