Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 96 / 164

ELECTRICAL COMPONENTS Solid State Speed Controller
Page 13-12 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
13
Speed Controller Installation
1. Install the four bolts (1) that hold the speed controller (2) to the component mounting plate and tighten
to 60 in-lb (6.8 N·m) (Figure 13-9, Page 13-11) .
2. Using the wiring diagram, install the multi-pin connectors and all wires as illustrated. See Wiring Dia-
grams, Section 11, Page 11-2. Tighten bolts (3) to 9 ft-lb (12.2 N·m) (Figure 13-9, Page 13-11) .
3. Install the speed controller cover. See Installing the Speed Controller Cover on page 13-8.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation:
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is in the
FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch is
in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
Figure 13-10 Speed Controller
#10 BLUE
#4 YELLOW
#4 GREEN
#10 WHITE
#4 BLK
#10 BLK
#10 BLK
#10 ORANGE
3
Typical 5 places