Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 105 / 164

BATTERIES Battery Replacement
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 14-3
14
4. Check and clean the battery rack and hold-downs. The nuts and bolts on the hold-downs may corrode.
It is therefore advised they be cleaned periodically and replaced as necessary.
5. Install batteries in the proper orientation (Figure 14-1, 14-2, or 14-3 on Page 14-3) . Install battery hold-
downs. Tighten to 55 in-lb (6.2 N·m), alternating between hold-down bolts. The hold-downs should be
tight enough so batteries do not move while vehicle is in motion, but not so tight as to crack or buckle bat-
tery case.
6. Install wires in proper sequence (Figure 14-1, 14-2, or 14-3 on Page 14-3) . Install black wire to negative
post of battery no. 8 last. Make sure all connections are tight. Tighten to 110 in-lb (12.4 N·m). Coat all ter-
minals with Battery Terminal Protector Spray (CC P/N 1014305) to minimize future corrosion.
7. Give the batteries a full charge prior to operation. This ensures all the batteries are fully charged and the
cells are equalized prior to use.
Figure 14-3 Battery Configuration (Turf 2, Carryall 2,
Carryall 6 (Style B))
(Viewed from driver side of vehicle)
1. Place TOW/RUN Switch in TOW before disconnecting or
connecting battery cables.
2. Remove negative battery cable.
3. Remove positive battery cable.
Connect battery cables in reverse order.
1
3
5
7
8
2
4
6
3
2
1
(+)
(–)