Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 99 / 164

ELECTRICAL COMPONENTS Battery Warning Light
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 13-15
13
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
BATTERY WARNING LIGHT
See General Warning, Section 10, Page 10-1.
Testing the Battery Warning Light
See Test Procedure 19, Section 11, Page 11-43.
Battery Warning Light Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove center dash. See step 2 of Key Switch Removal on page 13-1.
3. Disconnect the brown wire at the quick disconnect terminal and remove the orange/white wire from the
key switch.
4. Press the two retaining tabs (11) and remove the light from the center dash (Figure 13-12, Page 13-15) .
Battery Warning Light Installation
1. Install in reverse order of removal.
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
FERRITE BEADS – CE MARK VEHICLES
These beads bring the vehicle into compliance with EMC requirements for use in the European Union.
Ferrite Bead – IQ Plus Utility Vehicles
NOTE: If an IQ Plus utility vehicle being serviced or repaired is found to have beads in an arrangement
other than what is shown in this manual, relocate the beads to these updated locations.
Figure 13-12 Battery Warning Light
11