Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 86 / 164

ELECTRICAL COMPONENTS Key Switch
Page 13-2 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
13
3. Slide center dash panel up steering column by snapping top out and then rotating the panel out and up.
4. Disconnect the wires from the key switch. Do not allow wires to touch.
5. From the back of the dash panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the out-
side of the dash panel
(Figure 13-2, Page 13-2) .
Key Switch Installation
1. Position the key switch and flat washer (9) in the center dash, then install and tighten the switch retaining
nut (6) to 40 in-lb (4.5 N·m). Install key switch cap (8) in center dash (Figure 13-2, Page 13-2) .
2. Refer to the wiring diagram to connect the wires to the key switch terminals and tighten the terminal
screws to 7 in-lb (0.8 N·m). See Wiring Diagrams, Section 11, Page 11-2. Coat the terminals with Bat-
tery Terminal Protector Spray (CC P/N 1014305).
3. Install center dash by reversing removal procedure. Make sure key switch terminals (7) do not touch
frame and that the center dash panel is properly seated and snapped into place (Figure 13-2,
Page 13-2) .
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
Figure 13-2 Key Switch
4
6
8
9
7