Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 93 / 164

ELECTRICAL COMPONENTS Solenoid
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 13-9
13
5. Lift the solenoid (2) up and off of the component mounting plate.
Solenoid Installation
1. Mount solenoid (2) onto component mounting plate with screws (1) (Figure 13-7, Page 13-9) .
2. Tighten screws (1) to 60 in-lb (6.8 N·m).
3. Using the wiring diagram, install the wires, washers, and nuts onto the large mounting posts. Tighten nuts
to 77 in-lb (8.7 N·m). See Wiring Diagrams, Section 11, Page 11-2.
4. Install the blue/white and light blue wires onto the small terminals of the solenoid (Figure 13-7,
Page 13-9) .
5. Install speed controller cover. See Installing the Speed Controller Cover on page 13-8.
6. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
Figure 13-7 Solenoid
SOLENOID
2
1
TYPICAL
2 PLACES