Club Car IQ PLUS 2008, Дополнение к руководству по обслуживанию и ремонту

Страница: 95 / 164

ELECTRICAL COMPONENTS Solid State Speed Controller
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement Page 13-11
13
3. Connect the gray wire to the OBC.
4. Connect the black 6-gauge wire and black 10-gauge wire to the speed controller B– terminal with the
washer and bolt and tighten to 9 ft-lb (12.2 N·m) (Figure 13-8, Page 13-10) .
5. Plug the 6-pin connector from the OBC into the speed controller.
6. Connect the 24-pin connector to the speed controller.
7. Install a wire tie to tightly secure the speed controller wires to the component mounting plate
(Figure 13-6, Page 13-8) .
8. Install the speed controller cover. See Installing the Speed Controller Cover on page 13-8.
9. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.
SOLID STATE SPEED CONTROLLER
See General Warning, Section 10, Page 10-1.
Testing the Solid State Speed Controller
See Test Procedure 5, Section 11, Page 11-21.
Speed Controller Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove the speed controller cover. See Removing the Speed Controller Cover on page 13-7.
3. Disconnect all wires and multi-pin connectors from the speed controller.
4. Remove the four bolts (1) that hold the speed controller (2) to the component mounting plate and remove
the controller from the vehicle.
Figure 13-9 Speed Controller
1
2
NOTE: Some wires removed for clarity.