44-12
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
78-13315-02
Chapter 44 Configuring a VoIP Network
Configuring VoIP on a Switch
00-30-a3-4a-a0-00 to 00-30-a3-4a-a3-ff
15 00-d0-bc-ee-d0-dc to 00-d0-bc-ee-d1-1b 1.2 12.0(3)XE1 12.0(3)XE1
8 00-d0-c0-c8-83-ac to 00-d0-c0-c8-83-db 1.1 4.2(0.24)V6.1(0.37)FTL
9 00-50-3e-7c-43-00 to 00-50-3e-7c-43-2f 0.201 5.3(1)
Mod Sub-Type Sub-Model Sub-Serial Sub-Hw
--- ----------------------- ------------------- ----------- ------
1 L3 Switching Engine WS-F6K-PFC SAD03451187 1.0
9 Inline Power Module WS-F6K-VPWR 1.0
Console> (enable)
To display the version of modules and submodules, perform this task in normal mode:
This example shows the version of modules and submodules:
Console> (enable)
show version 2
Mod Port Model Serial # Versions
--- ---- ------------------- ----------- --------------------------------------
2 2 WS-X6K-SUP2-2GE SAD04450LF1 Hw : 1.1
Fw : 6.1(2)
Fw1: 6.1(3)
Sw : 6.3(0.62)PAN
Sw1: 6.3(0.62)PAN
WS-F6K-PFC2 SAD04440HVU Hw : 1.0
Console>
Power Management Modes
Each port is configured through the CLI, SNMP, or a configuration file to be in one of the following
modes (configured through the
set port inlinepower
CLI command):
•
Auto
—The supervisor engine directs the switching module to power up the port
only
if the
switching module discovers the phone.
•
Off
—The supervisor engine does not direct the switching module to power up the port even if an
unpowered phone is connected.
Each port also has a status, defined as one of the following:
•
on—Power is supplied by the port.
•
off—Power is not supplied by the port.
•
Power-deny—The supervisor engine does not have enough power to allocate to the port; power is
not being supplied by the port.
•
faulty—The port is unable to provide power to the connected device.
Task
Command
Display the version of modules and submodules.
show version
[
mod
]
