14-34
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
78-13315-02
Chapter 14 Configuring MLS
Configuring MLS
Using Debug Commands on the SCP
Table 14-10
describes the Serial Control Protocol (SCP)-related debug commands to troubleshoot the
SCP that runs over the Ethernet out-of-band channel (EOBC).
Displaying Global IP MMLS Information on the Supervisor Engine
These sections describe how to configure IP MMLS on Supervisor Engine 1:
•
Displaying IP MMLS Configuration Information, page 14-34
•
Displaying IP MMLS Statistics, page 14-35
•
Clearing IP MMLS Statistics, page 14-36
•
Displaying IP MMLS Entries, page 14-36
Note
IP MMLS is permanently enabled on Supervisor Engine 1 and cannot be disabled.
Note
To configure IP MMLS on the MSFC, see the
“Configuring IP MMLS on the MSFC” section on
page 14-28
.
Displaying IP MMLS Configuration Information
The
show mls multicast
command displays global IP MMLS configuration information and the state of
participating MSFCs.
To display global IP MMLS configuration information, perform this task:
Table 14-10 SCP Debug Commands
Command
Description
[
no
]
debug scp async
Displays trace for asynchronous data in and out of the SCP
system.
[
no
]
debug scp data
Shows packet data trace.
[
no
]
debug scp errors
Displays errors and warnings in the SCP.
[
no
]
debug scp packets
Displays packet data in and out of the SCP system.
[
no
]
debug scp timeouts
Reports timeouts.
[
no
]
debug scp all
Turns on all SCP debugging messages.
Task
Command
Display global IP MMLS configuration
information.
show mls multicast