12-7
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
78-13315-02
Chapter 12 Configuring InterVLAN Routing
Configuring InterVLAN Routing on the MSFC
To check which MSM interfaces are currently auto stated, perform this task in enabled mode:
This example shows how to check which MSM interfaces are currently auto stated (shutdown or brought
up through auto state):
Router#
show autostate entries
Port-channel1.5
Port-channel1.6
Port-channel1.4
Router#
Disabling the Auto State Feature
To disable the auto state feature if you have an MSM installed, perform this task in privileged mode:
The auto state feature is enabled by default. This example shows how to disable the auto state feature if
you have an MSM installed:
Console> (enable)
set msmautostate disable
MSM port auto state disabled.
Console> (enable)
To disable the line protocol state determination of the MSFC, perform this task in privileged mode:
Note
If you toggle (enable to disable and/or disable to enable) the
msfcautostate
command you might have
to use the
shutdown
and
no shutdown
commands to disable and then restart the VLAN and WAN
interfaces on the MSFC to bring them back up. Unless there is a valid reason, the MSFC auto state
feature should not be disabled.
This example shows how to disable the line protocol state determination of the MSFC:
Console> (enable)
set msfcautostate disable
MSM port auto state disabled.
Console> (enable)
Task Command
Check which MSM interfaces are currently auto
stated.
show autostate entries
Task
Command
Disable the auto state feature if you have an MSM
installed.
set msmautostate disable
Task Command
Disable the line protocol state determination of
the MSFC.
set msfcautostate disable