Cisco Small Business 300 1.1 Series, Руководство администратора

Страница: 663 / 706

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide 665
44
44.20 lldp med location
Use the lldp med location Interface Configuration (Ethernet) mode command to
configure the location information for the LLDP Media Endpoint Discovery (MED)
for a port. Use the no form of this command to delete location information for a
port.
Syntax
lldp med location {{coordinate data} | {civic-address data} | {ecs-elin data}}
no lldp med location {coordinate | civic-address | ecs-elin}
Parameters
•
coordinate
data
—Specifies the location data as coordinates in
hexadecimal format.
•
civic-address data —Specifies the location data as a civic address in
hexadecimal format.
•
ecs-elin
data
—Specifies the location data as an Emergency Call Service
Emergency Location Identification Number (ECS ELIN) in hexadecimal
format.
•
data—Specifies the location data in the format defined in ANSI/TIA 1057:
dotted hexadecimal data: Each byte in a hexadecimal character string is
two hexadecimal digits. Bytes are separated by a period or colon. (Length:
coordinate: 16 bytes. Civic-address: 6-160 bytes. Ecs-elin: 10-25 bytes)
Default Configuration
The location is not configured.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example configures the LLDP MED location information on
gi
2 as a
civic address.
console(config)# interface gi2
console(config-if)# lldp med location civic-address 616263646566