Cisco Small Business 300 1.1 Series, Руководство администратора

Страница: 297 / 706

Power over Ethernet (PoE) Commands
78-20269-01 Command Line Interface Reference Guide 298
23
23
Power over Ethernet (PoE) Commands
23.1 power inline
Use the power inline Interface Configuration mode command to configure the
inline power administrative mode on an interface.
Syntax
power inline {auto | never}
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
•
never—Turns off the device discovery protocol and stops supplying power
to the device.
Default Configuration
The default configuration is set to auto.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example turns on the device discovery protocol on port 4.
Console(config)# interface gi4
Console(config-if)# power inline auto
23.2 power inline priority
Use the power inline priority Interface Configuration (Ethernet) mode command to
configure the interface inline power management priority. Use the no form of this
command to restore the default configuration.
Syntax
power inline priority {critical | high | low}