Cisco Small Business 300 1.1 Series, Руководство администратора

Страница: 22 / 706

Introduction
78-20269-01 Command Line Interface Reference Guide 23
1
Accessing the Command Line Interface
The Command Line Interface (CLI) can be accessed from a terminal or computer
by performing one of the following tasks:
•
Running a terminal application, such as HyperTerminal, on a computer that is
directly connected to the Switch’s console port,
—or—
•
Running a Telnet session from a command prompt on a computer with a
network connection to the Switch.
•
Using SSH.
NOTE
Telnet and SSH are disabled by default on the switch.
If access is via a Telnet connection, ensure that the following conditions are met
before using CLI commands:
•
The switch has a defined IP address.
•
Corresponding management access is granted.
•
There is an IP path such that the computer and the switch can reach each
other.
Using HyperTerminal over the Console Interface
NOTE
When using HyperTerminal with Microsoft® Windows® 2000, ensure that
Windows® 2000 Service Pack 2 or later is installed on your computer. The arrow
keys will not function properly using HyperTerminal’s VT100 emulation in
Windows® 2000 prior to Service Pack 2. For information on Windows® 2000
service packs, go to www.microsoft.com.
The Switch’s RS-232 serial console port provides a direct connection to a
computer’s serial port using a standard DB-9 null-modem or crossover cable.
Once the computer and Switch are connected, run a terminal application to
access the Command Line Interface.