Cisco Small Business 300 1.1 Series, Руководство администратора

Страница: 52 / 706

Macro Commands
78-20269-01 Command Line Interface Reference Guide 53
3
WORD <1-32> Keyword to replace with value e.g. $DUPLEX, $SPEED
<cr>
Switch<config-if> # macro apply duplex $DUPLEX ?
WORD<1-32> First parameter value
<cr>
Switch<config-if> # macro apply duplex $DUPLEX full $SPEED ?
WORD<1-32> Second parameter value
Example 4 - The following example shows how to set the duplex mode of port gi1
to full and to set its speed to 100 Mb/s.
switch<config-if># interface gi1
switch<config-if># macro apply duplex $DUPLEX full $SPEED 100
3.2 macro apply
Use the macro apply/trace Interface Configuration command to either:
•
Apply a macro to an interface without displaying the actions being
performed
•
Apply a macro to the interface while displaying the actions being
performed
Syntax
macro {
apply | trace} macro-name [parameter-name1 {value}] [parameter-name2
{value}] [parameter-name3 {value} ]
Parameters
•
apply—Apply a macro to the specific interface.
•
trace—Apply and trace a macro to the specific interface.
•
macro-name—Name of the macro.
•
parameter-name value —(Optional) For each parameter defined in the
macro, specify its name and value. You can enter up to three
parameter-value pairs. Parameter keyword matching is case sensitive. All
matching occurrences of the parameter name in the macro are replaced
with the corresponding value.