S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
2-83
Cisco MDS 9500 Series Hardware Installation Guide
OL-17467-02
Chapter 2 Installing the Cisco MDS 9500 Series
Removing and Installing Clock Modules
Installing a Clock Module into the Cisco MDS 9509 Director
Caution
Always wear an ESD wrist strap when handling modules or coming into contact with internal
components.
To install the clock module, follow these steps:
Step 1
Remove the new clock module from the antistatic bag.
Step 2
Hold the module with the connectors away from you.
Step 3
Carefully press the module onto the two matching connectors on the backplane.
Note
You must install the new clock module in the same position that you removed it.
Step 4
Replace the four screws to secure the clock module onto the backplane.
Step 5
Repeat
Step 1
through
Step 4
to install any additional clock modules.
Step 6
Replace the back panel safety cover using the 18 screws.
Step 7
Provide power to the power supplies as described in the
“Connecting the Power Supplies” section on
page 2-28
.
Caution
In a system with dual power supplies, connect each power supply to a separate power source.
In case of a power source failure, the second source will most likely still be available.
Step 8
Verify power supply operation by checking that the power supply LEDs are in the following states:
•
INPUT OK LED is green.
•
FAN OK LED is green.
•
OUTPUT FAIL LED is off.
Removing a Clock Module from the Cisco MDS 9506 Director
Before replacing the clock module, check the contents of your kit.
Table 2-7
lists the contents of the
clock module replacement kit, part number DS-C9506-CL=.
Table 2-7
Contents of Cisco MDS 9506 Clock Module Replacement Kit
Quantity
Part Description
1
Cisco MDS 9506 clock module
12
M3 x 6-mm Phillips pan-head screws
1
Disposable ESD wrist strap
