3-37
Administrator’s Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
Configuring Gateway Settings
Configuring Basic BRI or PRI Port Settings
In the Basics section of the BRI Port or PRI Port tabs, you can configure basic settings for the specified
BRI or PRI port.
Procedure
Step 1
In the Gateway interface, on the sidebar, click
Gateway
(if not already selected).
Step 2
Click the applicable
BRI Port
or
PRI Port
tab.
Step 3
Select the
Port enabled
check box to enable this BRI or PRI port. For PRI gateways, if this setting is
unselected, the CD LED light on the rear panel of the gateway is disabled.
Step 4
(PRI gateways only) In the Port phone numbers section, choose one of the following option buttons:
•
Single Number
—Defines a single number for this BRI or PRI port. Enter a phone number in the
field.
•
Range
—In the two fields, enter a range of numbers for this BRI or PRI line. If the line has a range
of numbers, you only need to enter the digits necessary to indicate the range. For example, if the
phone numbers assigned to this line are 6775380 to 6775411, enter 380-411. You can type a
maximum of 31 digits in each text field.
Step 5
(PRI gateways only-Optional) In the
Local Area Code
field, enter the local area code for the phone
numbers. You can enter up to 16 digits.
Step 6
(PRI gateways only-Optional) Select the
Strip Local Area Code
check box if you want the gateway to
strip local area codes for outbound calls to the ISDN network.
Note
The type of line connected to this BRI or PRI port appears in the Physical Standard field.
Configuring BRI Port Physical Interface Settings
Note
This section only applies to the Cisco IPVC 3521 BRI Gateway.
In the Physical Interface section of the BRI Port tabs, you can configure the physical line properties of
the specified BRI port.
Procedure
Step 1
In the Gateway interface, on the sidebar, click
Gateway
(if not already selected).
Step 2
Click the applicable
BRI Port
tab.
Step 3
Click the
Physical Interface
button.
Step 4
Select the
Same as Port
check box if you want to duplicate physical interface settings from another BRI
port that you choose from the field. When selected, you cannot modify the
Signaling Protocol
or
Country
settings. This setting is selected by default.
Step 5
In the
Country
field, choose the country where the ISDN service is installed.
Содержание 3521
Страница 137: ......