![background image](http://html.mh-extra.com/html/cisco/3521/3521_administrators-manual_64813095.webp)
3-33
Administrator’s Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
Configuring Gateway Settings
Procedure
Step 1
In the Gateway interface, on the sidebar, click
Gateway
(if not already selected).
EnhancedBillingForVoiceCalls Instructs the gateway to support the Radvision ECS
CDR Real Connect Time
field. Real Connect Time
indicates the actual time at which an IP-to-ISDN voice
call connects to the ISDN terminal.
When disabled, the ECS uses the Connect Time field for
CDR billing purposes. Connect Time indicates the time
at which the Connect message is sent to the source
endpoint.
Parameters: Enable/Disable.
Remarks: Default value is disable. Relevant to voice
calls only. Operational only when the gateway is
registered to an ECS working in Routed Mode.
ForceG711ForMcu
Instructs the gateway to open only a G.711 channel in
gateway-to-Cisco IPVC 35xx MCU calls.
Parameters: Enable/Disable.
NotifyLevel
Changes the type and number of debug messages that are
generated.
Parameters:
0—Disables gateway logs.
3 (default)—Fatal error (Gateway can no longer provide
service), a problem affecting user functionality (for
example, call connect failure or no resources available),
or status prints for Customer Support use.
6—Debugging.
8—Extended debugging.
Remarks: We recommend that you do not exceed a
NotifyLevel of 6 as this might overload the system with
a very large debug message output. Level 3 should be
sufficient for normal usage.
Peer-to-Peer disconnect reason
add
Instructs the gateway under which circumstances to
reroute a call to different peer device.
Parameters: Enter a number representing the required
H.323 call disconnect reason, as listed in
Table 3-3
.
Peer-to-Peer disconnect reason
remove
Deletes the H.323 Call Disconnect Reason set by the
Peer-to-Peer disconnect reason add advanced command.
Parameters: ALL—Enter a number representing the
required H.323 call disconnect reason, as listed in
Table 3-3
.
Table 3-10
Advanced Command Settings (continued)
Command
Description
Содержание 3521
Страница 137: ......