![background image](http://html.mh-extra.com/html/cisco/3521/3521_administrators-manual_64813070.webp)
3-8
Administrator’s Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Chapter 3 Configuring the Cisco IPVC 3500 Series Gateway
Configuring Gateway Settings
•
Calls—Displays “Yes” or “No” to indicate whether or not there are currently any active calls
between the peer and gateway.
To change the order of peer devices used in peer hunting, select a peer device and click the up or down
arrow button to change its order.
To add or edit a peer device, click
Add
or select the peer device and click
Edit
. Perform the following
steps in the Add peer or Edit peer dialog box:
a.
In the
IP Address
field, enter or edit the peer IP address.
Note
Two peers cannot have the same IP address or host name/Uniform Resource Locator (URL).
b.
In the
IP Port
field, enter or edit the peer IP port number.
c.
In the
Description
field, enter or edit the description of the peer.
d.
Click
Upload
.
Note
You cannot add a single peer to the Peer list section more than once.
To delete a peer device, select the peer device and click
Delete
. Deleting a peer does not cause its active
calls to disconnect, but no new calls route to the deleted peer.
Note
The peer hunting process stops when one of the peer devices accepts the call or when the call is
rejected with a disconnect reason. When a gateway has scanned the Peer list section and still
cannot connect a call then the following rules apply: if at least one of the peers rejected the call
due to capacity overload, the call rejection reason (towards the call originator) is “No
Resources”; in all other cases, the call rejection reason is “Unreachable Destination.”
Step 7
In the
Peer hunting timeout (sec)
field, enter the length of time (between 1 and 10 seconds) for which
the gateway waits for a Transmission Control Protocol (TCP) response from each peer device contacted.
The default value is 5 seconds.
Step 8
Select the
Accept calls from defined peers only
check box if you want the gateway to reject incoming
calls from IP-side entities not defined in the peer list. If unselected, the gateway allows incoming calls
from IP-side entities not defined in the Peer list section.
Step 9
In the
Reject calls from peer devices when less than
n
B channels are free
field, enter the lower
capacity threshold for rejecting calls from H.323 peer devices. The default setting is 6.
About Peer-to-Peer H.323 Call Disconnect Reasons
Table lists the H.323 call disconnect reasons that the gateway peer-to-peer call hunting module uses.
Table 3-3
Peer-to-Peer H.323 Call Disconnect Reasons
Number
H.323 Call Disconnect Reason
1
There is no available bandwidth.
2
Gatekeeper resources have been exhausted.
3
The destination cannot be reached.
Содержание 3521
Страница 137: ......