2-17
Administrator’s Guide for Cisco IPVC 3521 BRI Gateway, Cisco IPVC 3526 PRI Gateway, and Cisco IPVC 3540 PRI Gateway
OL-7995-01
Chapter 2 Installing the Cisco IPVC 3500 Series Gateway
Viewing Board Basic Parameters
Step 4
To change the date and time, perform the following steps:
a.
In the
Change
field, select the
unit that you want to change.
b.
In the
Set board time to
field, click the up or down arrow to change that unit.
Note
There is no unit to change AM and PM. This designation rolls automatically when the hour
rolls past 12 backward or forward. Similarly, seconds rolls minutes, minutes roll hours,
hours roll days, and days rolls months.
c.
Repeat steps a-b for each unit you want to change.
d.
On the toolbar, click
Upload
to save your changes.
Setting the Gateway Location
You can install the gateway anywhere on your network including at a remote site. The Basics tab of the
Board section in the Gateway interface provides a field that you can use to identify the location where
the gateway is located
Procedure.
Step 1
On the sidebar, click
Board
.
Step 2
Click the
Basics
tab.
Step 3
In the
Location
field, enter the location information about the gateway that you want to display.
The field displays up to 23 characters.
Step 4
On the toolbar, click
Upload
to save to configuration memory.
Resetting Default Board Basic Settings
In the Basics tab of the Board section of the Gateway interface, you can restore board basic settings to
factory defaults.
Procedure
Step 1
On the sidebar, click
Board
.
Step 2
Click the
Basics
tab.
Step 3
Select the
Reset to default settings
check box.
Содержание 3521
Страница 137: ......
